INSTRUCTIONS
LU160™ INSTALLATION
RAB Lighting is committed to creating high-quality, aordable, well-designed and energy-ecient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
IMPORTANT
CAUTION:
TURN OFF POWER BY REMOVING POWER FUSE OR TURNING OFF CIRCUIT BREAKER BEFORE
INSTALLATION
The motion detector will not operate correctly if it is installed:
• Near an air conditioning and/or heating unit
• LU160 cannot be used with a dimmer switch, motion or occupancy sensor and other electronic switching devices unless otherwise
• These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
WARNING: RISK OF ELECTRICAL SHOCK
•
•
LUMINATOR
•
•
• Mount sensor away from heat producing sources to prevent
• Mount motion sensor away from moving objects such as trees
•
Fig: 1
•
•
• Position the lamp head in the general direction of the desired
• If needed, adjust the motion sensor up and down so the
Note: Do not mount this light xture on the ground.
To Next Page
Need help?
General
