10
10. Press OK button.
11. Press Close button.
12. Click the right button of mouse on your wireless Wi-Fi connection and then click the
Connect button.
13. Select Zond-12e or Python network and click the Connect button (check the
Connect automatically checkbox to connect to the network automatically in the
feature).
14. If you are using factory default Wi-Fi access point settings then follow to the next
point, otherwise chose the security method for Wi-Fi connection end enter pass code
if needed.
15. Close the Network and Sharing Center window.
For Windows 8 / 8.1 / 10:
1. Right-click on bottom left corner (on your Desktop), and then press Control Panel.
2. Chose the sub item View network status and tasks, of Network and Internet item.
3. Click the link Change adapter settings in the left part of Network and Sharing
Center.
4. Select your wireless Wi-Fi connection icon and click right mouse button on it. Select
the item Properties of the pop-up menu.
5. Select Internet Protocol Version 4 (TCP/IPv4 and then click the Properties button.
6. For GPRs manufactured after 2015 - click the Obtain an IP address
automatically option and continue from the point 10.
7. For GPRs manufactured before 2015 - click the Use the following IP address
option.
8. Click the IP Address box and enter 192.168.0.2 (if this address is occupied or is not
accessible, you could use any address from 192.168.0.2 to 192.168.0.254, except
occupied address 192.168.0.10. Please, consult with your network administrator
before changing IP addresses).
9. Click the Subnet mask box and enter 255.255.255.0.
10. Press OK button.
11. Press Close button.
12. Click the right button of mouse on your wireless Wi-Fi connection and then click the
Connect button.
13. Select Zond-12e or Python network and click the Connect button (check the
Connect automatically checkbox to connect to the network automatically in the
feature).
14. If you are using factory default Wi-Fi access point settings then follow to the next
point, otherwise chose the security method for Wi-Fi connection end enter pass code
if needed.
15. Close the Network and Sharing Center window.
Note: If during connection Set up network dialog appears (or Windows asks the PIN
code for the connection), please click the “Connect to the network without setting it up” link
(like it shown on the figure below).
To Next Page
Loading...