17
Programming the Weatheradio‚
already programmed into that
memory location appear.
4. If you select
SINGLE LOC, go to step
5. Otherwise, repeatedly press e
or d to select the memory location
where you want to store a FIPS
code.
5. To add a FIPS code or change the
displayed FIPS code, press g. The
FIPS code’s first digit flashes.
6. Repeatedly press g or f to move
the cursor backward or forward to
change the digit. Then repeatedly
press e or d until the desired digit
appears. Then press g. Ô
7. Repeat Step 6 for each digit you
want to change or add. Press g
when the last digit flashes. The
radio beeps and saves the FIPS
code. If the code is not in the
weatheradio’s database,
NEW
CODE? a
ppears. Press gagain to
save the FIPS code.
8. If you select
MULTIPLE LOC in step 4,
the FIPS code stored in the next
memory location appears. Repeat
5 -7 for each additional FIPS code.
Ô NOTE Ô
To erase the FIPS code,
To Next Page
Loading...
