4
Preparation
USING AC POWER
Your Weatheradio
can also use 6V,
300mA AC/DC adapter with plug size H
(not supplied) for normal operation.
With AC connected, normal operation
is allowed even if there are batteries in
unit.
1. Open the rubber DC 6V jack cover.
2. Insert the AC/DC adapter’s barrel
plug into
DC 6V jack. Then plug
the adapter into a standard AC
outlet.
POWER UP RESET
When powered on for the first time after
installing batteries, all LCD segments
turn on for one second. The device
starts to search for the best (strongest)
weather channel. Reset the
Weatheradio
to default settings by
following the steps below.Ô
1. Remove the batteries and/or
disconnect AC power.
2. Hold down
WX and re-insert
batteries or reconnect to AC
power. Hold down WX until USER
SETUP
appears and a short beep
sounds.
Ô NOTE Ô
The backlight is on
when receiving an alert
message, or for any key
operation.
To Next Page
Loading...
Need help?
General
