To review locked-out Talk Group IDs:
1. Press
PROG then TRUNK.
2. Press FUNC then L/OUT. The first locked
out ID appears. If the ID memory bank has
no locked-out ID, you hear the low beep
tone.
3. Press S or T to scroll through the list.
4. Press PROG to exit.
Turning Off Sub-Banks
To turn off a sub-bank:
1. Press
TRUNK repeatedly to select the
desired sub-bank.
2. Press FUNC then 1 to turn the sub-bank
on or off.
To turn off a sub-bank while scanning:
1. When the scanner stops on a transmission,
press FUNC.
2. Press TRUNK. The display indicates which
sub-bank is turned on or off. The active
sub-bank number appears.
3. Press FUNC and the number of the sub-
bank you desire to turn on or off. For
example to turn sub-bank 4 on or off,
press FUNC. Then press 4.
Note: This function activates when the
receiving channel bank is Closed mode.
Talk Group ID Hold
You can set your scanner to follow a trunking
signal that you want to track during scanning.
To set Talk Group ID Hold:
1. While the scanner is stopped on a voice
channel (“
VC”
appears), hold down
TRUNK until
“ID hold ON”
appears.
When the scanner receives a transmission,
the
“S”
on the display changes to
“H.”
2. To release ID hold, press SCAN or
TRUNK.
To Next Page
Loading...
