A Word About Safety
3
continuity function, resistance
measurement, or any of the battery test
or current measurement functions.
• Always discharge any capacitors of the
circuit under test before you attach test
leads.
• Always turn off power and disconnect the
test leads from the circuit before repla-
cing the meter’s batteries or the fuse.
• Never operate the meter unless its
back cover and battery cover are fully
closed and the screws fully tightened.
• Because many AC/DC sets have a
potentially hot chassis, be sure the top
of your workbench and the floor
underneath it are made of non-
conductive materials.
This meter is fully calibrated and tested.
Under normal use, no further adjustment
should be necessary. If the meter requires
repair, do not try to adjust it yourself. Take it
to your local RadioShack store.
o
Ô
The UL mark does not indicate that this
product has been evaluated by Underwriters
Laboratories for the accuracy of its readings.
Your meter requires three AAA batteries (not
supplied).
Your meter also has these additional
features.
Auto Power Off
— the meter turns itself off
after about 30 minutes if you do not change
any setting, helping conserve battery power.
Auto-Polarity Operation
— protects your
meter and gives valid measurements when
you connect the leads in reverse polarity.
o
WARNING
o
• USE EXTREME
CAUTION IN THE
USE OF THIS
DEVICE,IMPROPER
USE OF THIS
DEVICE CAN
RESULT IN INJURY
OR DEATH.
FOLLOW ALL
SAFEGUARDS
SUGGESTED IN
THIS OWNER’S
MANUAL IN
ADDITION TO
NORMAL SAFETY
PRECAUTIONS IN
DEALING WITH
ELECTRICAL
CIRCUITS. DO NOT
USE THIS DEVICE
IF YOU ARE
UNFAMILIAR WITH
ELECTRICAL
CIRCUITS AND
TESTING
PROCEDURES.
• IF THIS EQUIPMENT
IS USED IN A
MANNER NOT
SPECIFIED BY THE
MANUFACTURER,
THE PROTECTION
PROVIDED BY THE
EQUIPMENT MAY
BE IMPAIRED.
•TOREDUCETHE
RISK OF FIRE OR
SHOCK HAZARD,
DO NOT EXPOSE
THIS PRODUCT TO
RAIN OR
MOISTURE.
• FOR INDOOR USE
ONLY.
To Next Page
Loading...
Need help?
General
