Operation
6
1. Remove the plastic plugs from both test
leads.
2. Plug the black test lead’s right-angled end
into
–COM (common) on the front of the meter.
3a. Plug the red test lead’s right-angled end
into
+V.Ω.mA on the front of the meter.
OR
3b. To measure current higher than 400 mA,
plug the red test lead’s right-angled end into
+10AMAXon the front of the meter. Ô
OPERATION
TAKING ACCURATE
M
EASUREMENTS
For the most accurate reading, the
temperature should be between 65° and
83°F(18° and 28°C) (75% RH maximum).
TURNING THE METER
O
N/OFF AND
T
ESTING THE DISPLAY
To turn on the meter, rotate the function dial
to any function except
OFF.Toturnoffthe
meter, rotate the function dial to
OFF.
To test the meter’s display, turn off the
meter, and then hold down any button while
turning on the meter. The meter turns on
and all segments on the display appear.
Release the button you are holding down to
turn off the test.
CAUTION
• Be sure to select the
correct function
before you touch the
test leads to the
circuit or component
to be tested.
•Whenthemeterisno
in use, always leave
the function dial set t
OFF.
Ô NOTE Ô
• The meter sounds a
warning tone when
you set it to measure
anything except
current and connect
a test lead to
+10A
MAX
. This reminds
you not to touch the
circuit with the test
leads.
• If the function dial is
not set to
OFF and
nothing appears on
the display, the meter
might be in its auto
power shut-off mode.
Press any button or
rotate the function
dial to any position
except
OFF to turn on
the meter. If the
meter remains off,
set the function dial
to
OFF thensetitto
any function except
OFF.Ifthemeterstill
remains off, replace
the batteries (see
“Installing Batteries”
on Page 5).
To Next Page
Loading...
Need help?
General
