4
Safety Marks
Diode-Check Function — The meter
safely checks semiconductor junctions for
opens, shorts, or normal.
Battery Test Function
— Lets you easily
test batteries under load condition.
Overload and Transient Protection
—
helps protect the meter from accidental
overload in most ranges.
SAFETY MARKS
For your safety, we have added special markings to the meter’s panel to
remind you of the measurement limitations.
CAUTION
• Completely read this
manual before using
the meter.
• This meter passes
the stringent safety
tests required by
Underwriters
Laboratories.
The maximum current that this meter can measure at
this jack is 400 mA DC and AC.
Caution: Be extra careful when making high-
voltage measurements; DO NOT TOUCH
TERMINALS OR PROBE ENDS.
Caution: Risk of electric shock! Refer to the
complete operating instructions.
The meter is protected by double insulation.
CAT II
This equipment is rated for INSTALLATION
CATEGORY II (3600VA max.).
The maximum voltage that this meter can measure is
600V RMS AC or 600V DC. To avoid electric shock or
instrument damage, do not connect the two input ter-
minals (–COM and
+V.Ω.mA) to any source that
exceeds 600 volts with respect to earth/ground.
10A MAX.
UNFUSED
The maximum current you can measure at this jack is
10 amps DC/AC. This jack is not fuse-protected.
To Next Page
Loading...
Need help?
General
