Radio Shack HTX-202 - Touch-Tone Features; Manual and Stored Touch Tone Sending

USING TOUCH-TONE FEATURES
Your transceiver has a built-in 16-key touch-tone encoder. You can manually send
touch tones, or send the tones from one of five DTMF memories. You can also
set your transceiver so that it is silent until it receives a specific sequence of touch
tones.
Manually Sending Touch Tones
Some repeaters require you to enter a touch-tone code to key-up the repeater.
Also, some repeaters have autopatch devices that let you make telephone calls
through the repeater. To manually send the required tones, press and hold down
PTT. Then, enter the touch-tone digits.
Notes:
e You must press D twice to send the D digit.
¢ If the auto-reply feature is turned off, you can release PTT after you enter the first
digit. The transceiver continues to accept and transmit the touch-tone signals
until you pause at least 1 second.
Storing a DTIMF Memory Sequence
You can store frequently-used touch-tone sequences in the transceiver’s five DTMF
memories. Each memory can hold up to 15 digits. Follow these steps to store touch-
tone sequences.
1. Press and hold down F+OTMF for at least 1 second. The display changes
to show the first DTMF memory.
NO
. Press D. Then, press a digit from 1-5 to select one of the DTMF memories.
Go
. Enter the touch-tone sequence. If the sequence is less than 15 digits, press
D, then press a digit from 1 to 5 to select a different DIMF memory or press
PTT to exit the DIMF memory store mode.
Note: To enter a D, press D twice.