Operation
30
number, and the frequency
flash twice.
Ô
5. To search for another active
frequency, hold down ▲ or ▼
for about 1 second.
USING MONITOR
M
EMORY
Listening to a Monitor
Memory
To recall a frequency stored in a
monitor memory, press MAN then
MON/CL. , the monitor
memory number, and
CH flash
and the stored frequency appears.
Ô
To select other monitor memories,
enter the desired monitor
memory’s number (1–20), then
press MON/CL again or
repeatedly press MON/CL.
Moving a Frequency from
a Monitor Memory to a
Channel
1. Press MAN, enter the channel
number where you want to
store the frequency, then
press PGM.
2. Press MON/CL.,a
monitor memory number, and
CH flash, and the frequency
intheselectedmonitor
memory appears.
3. Enter the desired monitor
memory’s number (1
–20),
then press MON/CL again.
The selected monitor
memory’s frequency appears.
Ô NOTE Ô
• If you entered a
frequency that is
already stored in
another channel, -
dUPL- (duplicate)
and the lowest-
numbered channel
containing the
duplicate
frequency flash on
the display for
about 3 seconds.
Then the lowest-
available channel
number and
frequency flashes.
If you want to store
the frequency
anyway, press
ENT again. If you
do not want to
store the
frequency, press
MON/CL.The
scanner continues
to search.
Listening to a
Monitor Memory
• See Step 5 under
“Searching the
Service Banks” on
Page 26 for more
information about
storing a
frequency in a
monitor memory.
To Next Page
Loading...
