Radio Shack PRO-89 - Monitoring a Stored Channel; Clearing a Stored; Channel

Operation
32
To turn on a channel-storage bank
(1
–10) during scanning, press the
bank’s number key. A bar appears
under the bank’s number.
Ô
MONITORING A STORED
C
HANNEL
You can continuously monitor a
specific channel without scanning.
This is useful if you hear an
emergency transmission on a
channel and do not want to miss
any details — even though there
might be periods of silence — or if
you simply want to monitor that
channel.
1. Press MAN.
2. Enter the channel number
(1
–200).
3. Press MAN again.
CLEARING A STORED
C
HANNEL
If you no longer want a frequency
stored in a channel (and you do
not want to replace that frequency
with a different one), follow these
stepstoclearthestored
frequency.
1.
Press MAN to stop
searching or scanning
.
2. To select the desired channel
number, use the number keys
to enter that channel number
(1
–200).
3. Press PGM.
PGM appears.
4. Press 0 then ENT.The
frequency number changes to
Ô NOTE Ô
Turning Channel
Storage Banks Off
and On
• You cannot turn
off all banks.
There must be at
least one active
bank.
• You can manually
select any channel
in a bank, even if
the bank is turned
off.
• When you turn on
a bank during
scanning, the
scanner moves to
the selected bank
and scans it. If no
transmission is
found, the scanner
continues to scan
through all
selected banks.