42
3. When the scanner finds an active frequency, it stops
searching. To save the frequency into a channel in
the channel storage bank (bank 9 only), press
FUNC
then press
ENTER
.
Stored
@
9xx
appears on the
display (xx: channel number). Press or to con-
tinue searching for additional active frequencies.
Notes:
• During search, you can manually change the band
mode or frequency step. See “Changing the Receive
Mode” on Page 53 or “Changing the Frequency
Step” on Page 54.
• If bank 9 in the channel storage banks does not con-
tain any empty channels,
Bank
9
full
. appears on
the display’s lower line.
• To pause the search, press
FUNC
then press
STEP
.
**
PAUSED
**
appears on the display and the
scanner stops frequency search. To begin searching
again, press
FUNC
then press
STEP
or just press
SEARCH
.
Storing a Frequency While Searching for a
Specified Channel
Follow the steps to store a frequency into a specified
channel.
1. When the scanner stops on the frequency, press
FUNC
.
2. Press
TUNE
.
3. Press
MANUAL
. Select the specified channel using a
number key then press
MANUAL
again.
4. Press
PGM
.
5. Press
FUNC
, then press
TUNE
to store the frequency.
6. If desired, press
SEARCH
to return to the search
mode.
20-522.fm Page 42 Friday, September 17, 1999 12:46 PM
To Next Page
Loading...
