RADIOLINK ELETRONIC LIMITED
How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R12DSM.
3. There is a black button on the R12DSM, press the binding button twice in two seconds and
release, receiver light start blinking, after about 8 times blinking, match code success when
receiver signal LED always on!
Specification:
1) Channels: 12 channels
2) Working voltage: 4.8-6V
3) Working current: 40-180mA（input voltage: 5V）
4) Size: 30*15 MM
5) Weight: 2.5g
6) Detachable antenna
7) 4096 section precision, 0.5us per section, servo anti-shake rudder.
8) Control distance: about 1100 meters ground and 4000 meters air, actually control distance
depends on the environment.
Receiver’s Antenna Installation：
To obtain the best results of the diversity function, please refer to the following instructions:
1. The two antennas must be kept as straight as possible. Otherwise it will reduce the effective
range.
2. The two antennas should be placed at 90 degrees to each other.
To Next Page
Loading...
