RadioLink R8EF User Manual

Product Features
Radiolink R8EF, 2.4G 8 channels receiver, S-BUS , PPM and PWM signal support, use for Radiolink transmitter
T8FB.
Two signal working mode:
1.PWM signal output working mode：
Red LED indicates PWM signal output, 8 channels Totally.
2.S-BUS&PPM signal output working mode:
Blue/purple LED indicates SBUS&PPM signal output, 8 channels totally. SBUS and PWM signal possible working at
the same time with S-BUS&PPM signal output working mode.
CH1 output S-BUS signal, CH2 output PPM signal, CH3 to CH8 output PWM signal at the same time.

RadioLink R8EF Specifications

General

Modulation	GFSK
Number of Channels	8
Operating Voltage	4.0 - 8.4 V
Antenna Length	26 mm
Frequency Range	2.4 GHz
Signal Output	PWM
Compatibility	RadioLink transmitters AT9, AT10
Working Current	30mA(input voltage 5V)

Summary

Product Features

Signal Working Modes

Describes the different operating modes for signal output.

PWM Signal Output Mode

Red LED indicates PWM signal output, with 8 channels totally.

S-BUS & PPM Signal Output Mode

Blue/purple LED indicates SBUS&PPM signal output. Supports SBUS, PPM, and PWM signals simultaneously.

Signal Mode Switching

Quick press the ID SET switch twice to change signal from PWM to S-BUS&PPM.

Transmitter Binding Procedure

Step-by-step guide to bind the receiver with the transmitter.

Receiver Antenna Installation

Guidelines for optimal antenna placement to ensure effective range and avoid interference.

Technical Parameters

Channels

Specifies the number of channels supported by the receiver.

Working Voltage and Current

Details the operational voltage range and current consumption.

Physical Specifications

Provides dimensions and weight of the receiver.

Performance Specifications

Outlines precision, servo anti-shake, and control distance.