RadioLink R6FG User Manual

Radiolink Electronic Limited
www.radiolink.com
R6FG
(FHSS)
Radiolink R6FG, 2.4GHz 6 channels receiver, gyro integrated and HV servo supported.
Compatible with Radiolink 6 channels pistol grip radio RC6GS, 4 channels pistol grip radio RC4GS,
RC4G, RC3S and 8 channels transmitter T8FB.
How to Match Code with Transmitter:
1. Put the transmitter and the receiver close to each other within 50 centimeters.
2. Turn on the transmitter, then power on the R6FG.
3. There is a black button on the R6FG, press the binding button twice in two seconds and release,
receiver light starts blinking, after about blinking 8 times, match code success then receiver signal
LED always on!

RadioLink R6FG Specifications

General

Channels	6
Modulation	GFSK
Spread Spectrum	FHSS
Antenna Length	26mm
LCD Screen	No
Low Voltage Alert	Yes
Temperature Range	-10°C to +60°C
Waterproof	No
Compatibility	RadioLink transmitters
RF Power	<20dBm
Operating Current	30mA
Data Output	PWM/S-BUS
Frequency Range	2.4GHz ISM band (2400MHz~2483.5MHz)