RadioLink R6DSM - Dual Signal Operation; Transmitter Binding Procedure; Technical Specifications

Two signal working mode:
Red LED always, SBUS signal , 10 channels totally.
How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R6DSM.
3. Connect CH3 of R6DSM to ESC.
4. There is a black button on the R6DSM, press the binding button twice in two seconds and
release, receiver light start blinking, after about 8 times blinking, match code success when
receiver signal LED always on!
Specification:
1) Channels:
10 channels: output 10 channels signal, support SBUS signal, with red LED.
2) Working voltage: 4.8-10V
3) Working current: 38-45mA（input voltage: 5V）
4) Size: 15*13 MM
5) Weight: 1g
6) Detachable antenna
7) 4096 section precision, 0.25us per section, servo anti-shake rudder.
8) Control distance: about 600 meters, actually control distance depends on the environment.