RADWAG AS R2 User Manual

- 31 -
Variables depending on the currently used working mode
Variable
Description
Mode for which the variable is active
%W
Standard mass 1 pcs PARTS COUNTING
%H
High threshold
CHECKWEIGHING
%L
Low threshold
%A
Target mass DOSING
%B
Reference mass PERCENT WEIGHING
Non-standard characters used in designing non-standard printouts
\\
a single „\” character
\C
CRLF
\R
CR
\N
LF
\T
Tabulator
\F
Form feed (for PCL printers)
%E
Crop the paper for EPSON printers
Every single printout can contain max 160 characters (letters, numerals, non-standard characters,
spaces). You can apply non-standard characters depending on type of data that is to be printed out.
Example 1:
“RADWAG”
DATE: <current measurement date>
TIME: <current measurement time>
PRODUCT MASS: <current mass indication>
*****SIGNATURE:.........
<current working mode>
Enter printout content settings and design the printout using respective data variables and characters
for text format.
Example 2:
To crop the paper after the printout had been carried out by EPSON printer (if the printer is equipped
with an autocutter blade) the user must select (for a given printout: HEADER, GLP PRINTOUT or
FOOTER) an option of non-standard printout 1,2,3 or 4 with <%E> value available and select this
printout for a given printout settings.
In such case <SUFFIX> command should stay empty.
Paper must be cropped underneath the FOOTER.
Example settings:

RADWAG AS R2 Specifications

General

Readability	0.1 mg
Display	LCD (backlit)
Tare Range	-220 g
Linearity	±0.2 mg
Protection Class	IP43
Calibration	Internal
Interface	RS232, USB-A, USB-B
Power Supply	100 ÷ 240 V AC 50 / 60 Hz
Maximum Capacity	up to 220 g