RADWAG AS R2 User Manual

- 58 -
density determination
5
Beaker
11
Additional stand for a set of pans or a sinker
6
Hanger
12
Additional set of weighing pans for density
determination of solids with density lower that density
of water
Kit intended for AS and XA balances.
1
Beaker base
8
Hanger
2
Stand
9
Top weighing pan for solids density determination
3
Sinker
10
Flexible connector for weighing pans
4
Beaker
11
Bottom weighing pan for solids density determination
5
Thermometer holder
12
Additional sinker
6
Thermometer
13
Additional stand for a set of pans or a sinker
7
Flexible connector for
sinker
14
Additional set of weighing pans for density determination of
solids with density lower that density of water
Installation procedure:
AS balances
PS balances
CAUTION!
• Components of density determination kit shall be stored in a respective box.
• Weighing pans and sinker shall not be put directly on a table, this might cause their damage.
• Weighing pans and sinker, if not operated, shall be put on an additional stand.
• If the kit has been installed and -nuLL- message is displayed than the balance shall be loaded with
weights set (12). Thus prepared balance can be used for density determination.

RADWAG AS R2 Specifications

General

Readability	0.1 mg
Display	LCD (backlit)
Tare Range	-220 g
Linearity	±0.2 mg
Protection Class	IP43
Calibration	Internal
Interface	RS232, USB-A, USB-B
Power Supply	100 ÷ 240 V AC 50 / 60 Hz
Maximum Capacity	up to 220 g