E. Lead the cable (in excess) into the post, next fix the support foot under the
post:
7.2. Levelling
It is necessary to level the scale, do it by turning its feet. Keep turning the feet
until the air bubble takes central position.
7.3. Connecting the Scale to the Mains
The weighing device can be connected to the mains only with a power supply
that comes standard with the particular model. Nominal voltage of the power
supply (specified on the power supply data plate) has to be compatible with the
mains nominal voltage.
Procedure:
Connect the power supply to the mains. Plug it to the power supply socket
that is located on the scale's side.
Press key, it is to be found at the top of the operation panel.
Upon completed start-up, the home screen is displayed automatically.
To Next Page
Loading...
