AUTOTARE
Function allowing for automatic taring of the packaging during the weighing
process, when packaging mass for each of the product is different.
Description of this function is to be found further down this manual.
Deleting tare
Entered tare value can be deleted by pressing
button on the
balance’s overlay or by entering tare value of 0.000g (see description
above).
10.4. Settings for mode <WEIGHING>
The software allows the set-up of operating parameters (filters, value release
and autozero option, deleting the last digit and other settings) separately for
each working mode.
It enables customising the instrument and utilising properties depending on the
user’s needs and expectations or specific requirements for selected working
mode (e.g. DOSING); as a result the work is quick and easy.
Available settings
P2.2.1 – READOUT
P2.2.1.1 – FILTER [V.FAST/ FAST / NORMAL / SLOW / V. SLOW]
P2.2.1.2 – RESULT CONF. [REL. / FAST / FAST+REL.]
P2.2.1.3 – AUTOZERO [YES / NO]
P2.2.1.4 – LAST DIGIT [ALWAYS / NEVER / WHEN STAB.]
P2.2.1.5 – AMBIENT CONDITIONS (STABLE/UNSTABLE)
P2.2.2 – AUTOTARE [YES / NO]
P2.2.3 – PRINT MODE
P2.2.3.1 – MODE [EACH / WHEN STAB. / AUTO]
P2.2.3.2 –AUTO. PROG
P2.2.4 – UNITS
P2.2.4.1 – AVAILABILITY
P2.2.4.2 –START UNIT [G]
P2.2.4.3 – USER UNIT1
P2.2.4.4 – USER UNIT2
P2.2.5 – INFORMATION [TARE / NETTO / GROSS / USER / PRODUCT /
/NSTD. INF. / NONE]
P2.2.6 – INF. NSTD. (non-standard information – any text, max 19 characters)
P2.2.7 – SHORTCUTS (available options depending on the working mode)
P2.2.7 1 – F1 [NONE / ENTER TARE/ …]
P2.2.7.2 – F2 [NONE / ENTER TARE / …]
P2.2.7.3 – F3 [NONE / ENTER TARE/ …]
P2.2.7.4 – F4 [NONE / ENTER TARE / …]
To Next Page
Loading...
Need help?
General