10.7 Temporary measuring unit
This function is only available in <WEIGHING> mode. In other modes
measurements are only possible in basic unit [g].
Function enables selecting a measuring unit which will be indicated next to
mass reading during the weighing process. Set measuring unit will be in use
from the moment of its activation until its change or switching off and on the
balance.
Each press of the
button causes change of the measuring unit.
Available settings:
• For verified balances, a user can select from the following: [g], [mg] or
[kg], [ct]
• For non-verified balances, a user can select from the following measuring
units: [g], [mg], [kg], [ct], [lb], [oz], [ozt], [dwt], [tlh], [tls], [tlt], [tlc], [mom],
[gr], [ti], [N]
10.8 Start-up measuring unit
This function is only available in <WEIGHING> mode. In other modes
measurements are only possible in basic unit [g].
After selecting the start-up unit, when switched on, the balance will work in
<WEIGHING> mode with this very unit.
The units which can be selected are determined by the balance’s status, i.e.
whether the balance is verified or non-verified.
Procedure:
To Next Page
Loading...
Need help?
General