12.4. Autozero function
Dla zapewnienia dokładnych wskazań wagi wprowadzono programową funkcję
„AUTOZERO”. Zadaniem tej funkcji jest automatyczna kontrola i korekta zerowego
wskazania wagi.
If AUTOZERO function is enabled, then each weighing process starts from precise zero
point. There are, however, some cases when this function can be a disturbing factor of
measuring process; for instance very slow placing of a load on the weighing pan (e.g. load
pouring) – in such case system of zero indication correction can also correct actual
indication of loaded mass. AUTOZERO function is enabled or disabled in parameter P4 03
as specified in point 6.1.1 of this user manual.
12.5. Last digit
In order to ensure adequate operating comfort with a balance, the user can determine
presence of the last digit on the display and criteria of its displaying.
Available settings are:
- 0 never
- 1 always
- 2 when stable
12.6. Negative
The function aids previewing mass value and other indications on the display. Depending
on user needs it is possible to enable or disable the function.
12.7. Operating conditions
This parameter enables two settings: stable or unstable. Setting the parameter to stable
causes much faster operation of the balance, i.e. the weighing time is shorter than
compared to setting: unstable. This parameter refers to operating and ambient conditions
at a workstation. If the conditions are unstable, then it is recommended to set the
parameter to unstable. The default setting of the parameter is: stable.
To Next Page
Loading...
Need help?
General