RADWAG R Series User Manual

- 84 -
OUH
Give value of max checkweighing threshold
SM
Set mass value of a single item
TV
Set target mass value
RM
Set reference mass value
NB
Give balance serial number
SS
Value release
IC
Internal adjustment performance
IC1
Disable automatic internal adjustment of the balance
IC0
Enable automatic internal adjustment of the balance
K1
Lock balance keypad
K0
Unlock balance keypad
OMI
Give available working modes
OMS
Set working mode
OMG
Give current working mode
UI
Give accessible units
US
Set unit
UG
Give current unit
BP
Activate sound signal
PC
Send all implemented commands
BN
Give balance type
FS
Give Max capacity
RV
Give program version
A
Set autozero function
EV
Set ambient conditions state
EVG
Give currently set ambient conditions
FIS
Set filter
FIG
Give current filter
ARS
Set value release
ARG
Give current value release
LDS
Set last digit
NT
Cooperation with PUE 7.1, PUE 10 terminal
CAUTION!
Each command must end with CR LF characters;
15.2. RESPONCE FORMAT
On receipt of a command, the terminal responds as follows:
XX_A CR LF
command understood and in progress
XX_D CR LF
command carried out (appears only after the command XX_A)
XX_I CR LF
command understood but not accessible at this moment
XX _ ^ CR LF
command understood but max threshold is exceeded
XX _ v CR LF
command understood but min threshold is exceeded
XX _ OK CR LF
command carried out
ES_CR LF
command not recognised
XX _ E CR LF
time limit exceeded while waiting for stable measurement result
(time limit is balance characteristic parameter)
Where:
XX - name of a sent command
_ - spaces

RADWAG R Series Specifications

General

Brand	RADWAG
Model	R Series
Category	Scales
Language	English