Radwin Transportation FiberinMotion - Configuring Indoor Synchronization Units (ISUs)

FinMInstallationGuide Release4.5.25 2‐12
TBSMounting SiteInstallation
2. PlacethisassemblyonthepolewhereyouwanttomounttheTBS.Onceitisinplace,
rotatethepoleclampasshown,thentightenbothbolts.
HorizontalPole‐medium
1. Diameter2to3:BeforeraisingtheTBSonthepole,positionthepoleclampasshownin
thefollowingtwofigures.Donotcompletelytightenthebolts:
Figure2‐22:Thinpole:Rotateclamp Figure2‐23:Thinpole:tightenbolts
Figure2‐24:Mediumpole:Fastenclampto
baseplate
Figure2‐25:Mediumpole:Donotcom‐
pletelytightenbolts