Radwin Transportation FiberinMotion - Figure 2-78 Placing and Figure 2-79 Inserting the

FinMInstallationGuide Release4.5.25 2‐41
TMUMounting SiteInstallation
9. Placeeachmountingslidewiththestoppingflaptowardstherearoftherack,and
usingthePhilipsscrewswiththeblackwashers,fastenthemountingslidestothe
cagenutsandtighten.

Figure2‐78:Placingandfasteningmountingslide
10.Oncebothmountingslidesarefastenedtightlyontherack,insertthedraweras
follows:
a. Placetheframeworkarmsofthedrawerintothemountingslidescarefully.Make
suretheyarestraight.
b. Pushbackthedraweruntiltheframeworkarmstouchtheball‐bearinggrey
housing.
c. Whilepressingoutwardsonbothball‐bearinggreyhousings,pushthedrawerin
furtheruntilthefr
ameworkarmsengagetheball‐bearinghousings.
d. Furtherpushthedraweruntilthelockingleverstopsit.
e. Releasethelockinglevers,andpushthedrawerinallthewa y,eventhroughsome
resistancetowardstheend.