Radwin Transportation FiberinMotion - TMU Mounting Using the TMU-Poe Drawer

FinMInstallationGuide Release4.5.25 2‐36
TMUMounting SiteInstallation
TMUMountingUsingtheTMU‐PoEDrawer
TheTMU‐PoEdrawerisusedtomountboththeTMUandthePoEtogether.Carryoutthe
followingstepstomountbothunits:
1. ChooseasitefortheTMU‐PoEdrawerascloseaspossibletotheon‐boardantennasand
on‐boardpowersupply.Makesurethereisatleast12cm(5in)ofrackspace.
2. Openthepackage,removetheTMU‐PoEdrawerfromthepackingstyrofoam,and
cutanddiscardthetwoblackstrapsholdingthemountingslidesinplace.
3. Checkthecontents:
Table2‐4:TMU‐PoEdrawerpackagecontents
Item
No.
Description Quantity
1
Tray 1
2
DC‐TMUJumpercable 1
3
Allenwrench(M4) 1
4
Allenscrews(M4x22) 8
5
SpringwashersforAllenscrews 8
6
DINscrews(M5x16) 12
7
BlackfinishingwashersforM5screws 12
8
Mechanicalcage/nutsforM5screws 12