Radwin Transportation FiberinMotion - Figure 2-66 Exposing the Tacky; Figure 2-67 Waterproofing

FinMInstallationGuide Release4.5.25 2‐32
Waterproofing SiteInstallation
2.2.9Waterproofing
Protectallconnectionsbetweenanyoutdoordevicesandcablesfromrain,dust,moisture
andsaltaccordingtotheprocedurebelow:
1. UseahighqualitysealingmaterialsuchasScotch23Tape¾”wide,toensureIP‐67
compliantprotectionagainstwateranddust.
2. Cuttwopieceseach25cmlong,ofScotch23splicingtape.Removetheplastic
covertoexposethetackysideofthesealingtapeasshowninFigure 2‐66.
Figure2‐66:Exposingthetackysideofthesealingtape
3. Afterconnectingacabletoaunit,tightenthecableglandcapfirmlyandusethe
insulationtapetofullycoverthecablegland.

Figure2‐67:Waterproofinganexternalconnection