Radwin Transportation FiberinMotion - Figure 2-41 Connect Polec; Figure 2-42 Tighten Bolts; Figure 2-43 Rotate Clamp and Figure 2-44 Mounting Kit on; Holder

FinMInstallationGuide Release4.5.25 2‐19
TBSAntennas SiteInstallation
equaltotheradiusofthepole.Youwillthenhaveone“unit”thatyoucantaketo
thelocationonthepolewhereyouwanttomounttheantenna.(SeeFigure 2‐37
toFigure 2‐40formountingonathinpole)
4. Placethis“unit”onthepolewhereyouwanttomounttheantenna.Onceitisin
place,rotatethepoleclampasshown,thentightenbothbolts.
ThickPole
• ThismethodisformountingtheTBSantennaonapoleofpipesizelargerthan3in.
• Usewormdriveclamps(notsupplied),threadedthroughtheholesasshown.Thepole
clampisnotn
eeded.
Figure2‐41:ConnectPoleClamptoRadio
Holder
Figure2‐42:Tightenbolts
Figure2‐43:RotateClampandtightenbolts Figure2‐44:MountingKitonpole