Radwin Transportation FiberinMotion - Figure 2-37 Connect Polec; Figure 2-38 Tighten Bolts; Figure 2-39 Rotate Clamp and Figure 2-40 Mounting Kit on

FinMInstallationGuide Release4.5.25 2‐18
TBSAntennas SiteInstallation
1. Whenmountingonathinpole,positionthepoleclampasshowninthefollowingfigures:
2. Placethis“unit”onthepolewhereyouwanttomounttheantenna.Onceitisin
place,rotatethepoleclampasshown,thentightenbothbolts.
MediumPole
ThismethodisformountingtheTBSantennaonapoleofpipesize2to3in.
3. Connectthepoleclamptotheradioholderwiththe8x90bolts,butdonottighten
theboltsalltheway‐tightenthemsothattheyarenotcloserthanadistance
DonotmounttheTBSantennaonapolesmallerthan3/4in.
Figure2‐37:ConnectPoleClamptoRadio
Holder
Figure2‐38:Tightenbolts
Figure2‐39:RotateClampandtightenbolts Figure2‐40:MountingKitonthinpole