Rae QRAE 3 User Manual

18
8.3. Menus And Submenus
In Programming Mode, menus and submenus are organized as shown here:
Calibration
Measurement
Alarms
Datalog
Monitor
Wireless*
Multi Bump
Sensor On/Off
Alarm Limits
Clear Datalog
Date And Time
Radio On/Off
Multi Zero
Meas. Unit
Alarm Mode
Interval
Display
Roaming
Multi Span
LEL Meas. Gas
Alarm Settings
Sensor Selection
Pump
Speed**
PAN ID
Single Bump
Exit
Comfort Beep
Data Selection
Site ID
Channel
Single Zero
Man Down
Alarm
Datalog Type
User ID
Join Network
Single Span
Exit
Action When
Full
User Mode
Interval
Set LEL Cal.
Gas
Exit
Zero At Start
Off Network
Alarm
Set Span Value
Exit
Factory Reset
Exit
Exit
* Wirelessly equipped versions only.
** Pump-equipped version only.
8.3.1. Editing And Selecting Parameters And Sensors
There are a few basic ways to edit parameters, select sensors, and perform other activities
in the QRAE 3. The actions performed by pressing keys always match 1-to-1 with the
boxes along the bottom of the display and the two keys. Some parameters are edited by
scrolling and selecting individual items (black bars behind white text act as highlighters).
Some include a choice via “radio keys,” where only one item in a list can be selected,
while other menus use boxes for you to “check” with an “X,” and these allow for
multiple items in a list to be selected. In all cases of editing, you can save or undo your
choice.

Rae QRAE 3 Specifications

General

Brand	Rae
Model	QRAE 3
Category	Monitor
Language	English