Need help?Do you have a question about the Rae RAEGuard 2 PID and is the answer not in the manual?
General| Sensor Type | Photoionization Detector (PID) |
|---|---|
| Detection Range | 0 to 2, 000 ppm |
| Response Time (T90) | <3 seconds |
| Lamp Energy | 10.6 eV |
| Battery Type | Rechargeable Li-ion battery |
| Battery Life | Up to 24 hours |
| Ingress Protection | IP65 |
| Gas Detected | Volatile Organic Compounds (VOCs) |
| Display | LCD with backlight |
| Alarms | Audible, visual, and vibration alarms |
| Data Logging | Yes |
| Operating Temperature | -20°C to 50°C |
| Operating Humidity | 0 to 95% RH (non-condensing) |
| Resolution | 0.1 ppm (0-199.9 ppm), 1 ppm (200-2000 ppm) |
| Dimensions | 120 x 67 x 35 mm (4.7 x 2.6 x 1.4 in) |
Details the technical specifications of the RAEGuard 2 PID instrument.
Instructions for the environmentally sound disposal of the product at its end of life.
Guidance on how to mount the RAEGuard 2 PID transmitter.
Step-by-step instructions for safely disassembling the instrument.
Information regarding the terminal blocks and wiring of the detector.
Detailed steps for connecting wires to the terminal blocks.
Procedures for ensuring proper external and internal earth grounding.
Configuration of alarm contacts and relay operations.
Overview of the RAEGuard 2 PID's display, LED, and keys.
Details on the magnetic key used for operating the unit's switches.
Instructions on how to interact with the unit's interface using the magnet key.
Describes the instrument's startup sequence and warm-up process.
Explanation of how the instrument displays readings and performs checks.
Summary of the instrument's status indicators, LEDs, and LCD messages.
Steps to access the instrument's programming mode using the magnetic key.
Overview of the available zero and span calibration procedures.
Settings for measurement units, range, and gas selection.
Configuration of high and low gas concentration alarm limits.
Settings for temperature units, language, and pump parameters.
Procedure for performing a zero calibration using zero gas.
Procedure for performing a span calibration using span gas.
Defines the scope of the document regarding RAEGuard 2 PID and DigiPID system aspects.
Lists the sections controlled by the Notified Body.
Information on the responsibility for the controlled sections of the manual.
Lists the controlled sections including safety-related information.
To Next Page
