Rae RAEGuard 2 PID - 26 Electronic Waste Disposal

88 pages

Save Page as PDF

To Next Page

To Previous Page

RAEGuard 2 PID User’s Guide

26 Electronic Waste Disposal

At the end of its life, this product must undergo separate

collection and recycling from general or household

waste.

Main Page

Default Chapter2
- Table of Contents2
Section 1: Raeguard 2 PID User's Guide6
1 General Information7
2 General Specifications9
- Raeguard 2 PID Specifications9
- Proper Product Disposal at End of Life10
3 Operation11
4 Physical Description12
5 Physical Dimensions12
6 Installation and Access Instructions13
- Mounting13
- Instrument Disassembly15
- Electrical Wiring16
- Wiring Procedure17
- Earth Grounding Instructions18
- Alarm Contact Setup19
7 Display and User Interface21
- User Interface21
- Magnet Key21
- Using the Magnet Key22
- System Initialization22
- Reading Display22
- Instrument Status Display23
8 Navigating Settings24
9 Programming Menus28
- Zero/Fresh Calibration28
- Meas. Unit28
- High Alarm28
- Temp. Unit28
- Span Calibration28
- Meas. Range28
- Low Alarm28
- Language28
- Set Span Value28
- Entering Programming Mode29
- Calibration30
- Measurement (Advanced Mode)32
- Alarm Setting36
- Monitor Setup38
10 Calibration44
- Zero Calibration45
- Span Calibration47
11 Alarm Signal Summary49
12 Maintenance50
13 Troubleshooting50
14 Appendix A: Range, Sensor and Related Configuration51
- 14 Appendix A: Range, Sensor and Related51
15 Modbus/Rs-485 Information51
16 Appendix B: Controlled Section53
- Scope53
- Contents53
- Scope55
- Responsibility55
- Contents55
Section 2: Digipid User's Guide62
- Safety Instructions63
17 Read before Operating63
- Digipid Marking64
- Operation Area and Conditions65
  - Hazardous Areas Classified by Zones65
  - Hazardous Areas Classified by Divisions65
- Instruction for Safe Use65
- Use in Hazardous Areas66
- Year of Manufacture66
- Specifications67
18 General Information68
19 Grounding (Earth Connection)69
20 Physical Description70
21 Sensor Parts and Dimensions71
22 Operating the Sensor Module72
- Preparing the Sensor for Use72
23 Using the Sensor Module73
- Gas Flow Routing Connection73
- Sensor Module Calibration74
- Maintenance and Calibration75
- Replacing the Lamp and Filter75
24 Replacing the Sensor's Teflon UV Shield77
25 Sensor & Lamp Cleaning/Replacement80
- Cleaning the PID Sensor80
- Cleaning the Lamp Housing or Changing the Lamp81
- Cleaning the Instrument82
- Ordering Replacement Parts82
- Special Servicing Note82
26 Electronic Waste Disposal83
27 Technical Support84
28 RAE Systems Contacts84
- Product Registration88

Rae RAEGuard 2 PID - 26 Electronic Waste Disposal

Table of Contents

Related product manuals