Rain Bird ESP-7ME3 - Display Indicators

ESP-ME3 Controller
9
EN
AUTO
AUTO is the normal operating mode. Return the dial to
AUTO when programming is complete.
During Watering:
The display shows a blinking sprinkler symbol, the
active Station Number or Program, and the Remaining
Run Time.
• To cancel watering, turn the dial to OFF for three
seconds until the screen shows OFF.
To Manually Start a Program:
a
Press the Program Select button to select a
program.
b
Press and hold the Hold to Start button to
immediately start manual watering for the
selected program.
OFF
Turn the dial to OFF to stop automatic irrigation or to
cancel all active watering immediately.
NOTICE
Watering will NOT occur if the controller remains in
the OFF position.
B
NOTE: Manual watering can be started using
mobile apps or LIMR when dial is in OFF position.
Display Indicators
Display Func-
tion
Description
ALL
ALL All stations
CLEARED
CLEARED
Programming was
cleared
CYCLIC
CYCLIC
Watering occurs at
specific intervals, such
as every 2 days
DELAY
DELAY Delay Watering Active
EVEN
EVEN Even days watering
FLOW
FLOW Flow Sensor
MV ON
MV ON
Master or Pump-start
relay is active
NOMOD
NOMOD
No station modules
installed for that station
ODD
ODD Odd days watering
OFF
OFF
Controller will not
water
PERMOFF
PERMOFF
Permanent days off
for Odd, Even, Cyclic
watering
RAIN
RAIN Rain Sensor
RESTORD
RESTORD Programming restored
SAVED
SAVED Save programming
SENS ON
SENS ON
Sensor will function if
wired
SEN OFF
SEN OFF
Sensor is ignored even
if wired
SKIP
SKIP
Station not used due to
station module config-
uration
SOAK
SOAK
Soak time between wa-
tering times - support-
ed through the Rain
Bird app.