Operating the Controller, continued
24
Operating Automatically
To operate the controller automatically,
Rotate the dial to AUTO.
The controller runs each of the programs as you
have specified.
Note: The controller will operate automatically in any
position except for OFF. However, there will be no
display of the day, time or program status. When the
controller is in the OFF position, the controller will
not operate.
Operating Manually
There are a number of functions you can perform
manually. Each one is described in this section.
Operating a Program or
Programs Manually
You can select, start and manually advance
programs for semi-automatic operation.
To do so,
1. Rotate the dial to AUTO.
The display shows the day of the week and the
time of day.
2. Press PGM until the program you wish to
operate is displayed.
3. Press MAN START/ADV to start the selected
program.
4. If you want to operate more than one program,
press PGM to select another program and
press MAN START/ADV again.
The second program runs when the first is
complete. You can stack all four programs in this
way.
To Next Page
Loading...
Need help?
General
