RainPoint ITV201P - USE ONLY ONE OF THE ZONES; OFF MODE; BATTERY STATUS

USE ONLY ONE OF THE ZONES
OFF MODE
BATTERY STATUS
If you want to use only ZONE L and close
ZONE R, please set it up as follows.
1) Turn the dial to "Sta Time" and press "Zone"
to select ZONE R.
2) Press "P" button to switch Plan, then press the
"+" or "-" button to adjust the Hour until the
screen displays OFF.
3) Turn the dial to "ON" to save the changes.
1) If you wish to stop all watering plan for an
extended period, turn the dial to "OFF".
(Your settings are saved)
2) The timer will not water automatically while in
OFF mode. (The screen will display the word
OFF in large letters)
3) To sta watering automatically again, turn the
dial back to "ON" to resume your programmed
watering schedule.
* If you only want to use ZONE R and close ZONE L, the same applies.
Batte status will be displayed as following:
Note: NOTE
When the low batte indicator appears on display. The valve will
close automatically to avoid leakage. Please replace the batte in time
in case of interrupting normal operation.
Full LOW Power
TIPS:
1. If you need to turn o only one ZONE completely, the P1, P2, and
P3 of the ZONE need to be set to the "OFF" state at the same time,
otherwise, the plans that are not set to the "OFF" state will continue
to work.
- 19 -
EN