98 GETTING TO KNOW YOUR VEHICLE
2. With the side gates open, position the
divider so the outboard ends align with the
intended slots in the sides of the bed.
Aligning Gate To Slots
3. Rotate the side gates closed so that the
outboard ends are secured into the
intended slots of the bed.
4. Rotate the center handle horizontally to
secure the side gates in the closed position.
Side Gates Closed
5. Lock the center handle to secure the panel
into place.
Bed Rail Tie-Down System — If Equipped
NOTE:
This feature is available for vehicles both
equipped, or not equipped, with a RamBox.
There are two adjustable cleats on each side of
the bed that can be used to assist in securing
cargo.
Adjustable Cleats
Each cleat must be located and tightened down
in one of the detents, along either rail, in order
to keep cargo properly secure.
CAUTION!
The maximum load per cleat should not
exceed 250 lbs (113 kg), or 500 lbs (227 kg)
total per rail, and the angle of the load on
each cleat should not exceed 45 degrees
above horizontal, or damage to the cleat or
cleat rail may occur.
20_DT_OM_EN_USC_t.book Page 98
To Next Page
Loading...
