RAM 1500 2020 - Vehicle Security Alarm; To Arm the System; To Disarm the System

GETTING TO KNOW YOUR VEHICLE 25
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no
cause interferencia perjudicial y
2. este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user’s authority to operate
the equipment.
VEHICLE SECURITY ALARM
The vehicle security alarm monitors the vehicle
doors, tailgate, and ignition for unauthorized
operation. When the vehicle security alarm is
activated, interior switches for door locks are
disabled. The system will turn the horn off after
29 seconds, 5 seconds between cycles, up to
8 cycles if the trigger remains active and then
the vehicle security alarm will rearm itself.
To Arm The System
Follow these steps to arm the vehicle security
alarm:
1. Remove the key from the ignition system.
Refer to "Starting The Engine" in "Starting
And Operating" for further information.
 Make sure the vehicle ignition system is
OFF.
2. Perform one of the following methods to
lock the vehicle:
 Push the lock button on the interior
power door lock switch with the driver
and/or passenger door open.
 Push the lock button on the exterior
Passive Entry Door Handle with a valid
key fob available in the same exterior
zone. Refer to "Keyless Enter-N-Go —
Passive Entry" in “Doors” in this chapter
for further information.
 Push the lock button on the key fob.
3. If any doors are open, close them.
The vehicle security alarm will set when you use
the power door locks, or use the key fob to lock
the doors. After all the doors are locked and
closed, the vehicle security light, in the
instrument panel cluster, will flash rapidly for
about 16 seconds to indicate that the alarm is
being set. After the alarm is set, the vehicle
security light will flash at a slower rate to
indicate that the system is armed.
To Disarm The System
The vehicle security alarm can be disarmed
using any of the following methods:
1. Push the unlock button on the key fob.
2. Grasp the Passive Entry Unlock Door Handle
with a valid key fob within 5 ft (1.5 m) of the
passive entry door handle. If equipped, refer
to "Keyless Enter-N-Go — Passive Entry" in
“Doors” in this chapter for further
information.
3. Cycle the ignition out of the OFF position.
2
20_DT_OM_EN_USC_t.book Page 25