RAM 1500 2020 - Dual Pane Power Sunroof - if Equipped

72 GETTING TO KNOW YOUR VEHICLE
Venting Sunroof — Express
Push and release the Vent button within one
half second and the sunroof will open to the
vent position. This is called “Express Vent”, and
it will occur regardless of sunroof position.
During Express Vent operation, any other
actuation of the switch will stop the sunroof.
Sunroof Maintenance
Use only a non-abrasive cleaner and a soft cloth
to clean the glass panel.
Ignition Off Operation
The power sunroof switch will remain active for
up to approximately 10 minutes after the
ignition switch is placed in the OFF position.
Opening either front door will cancel this
feature.
NOTE:
Ignition Off time is programmable through the
Uconnect System. Refer to “Uconnect Settings”
in “Multimedia” for further information.
Relearn Procedure
For vehicles equipped with a sunroof, there is a
relearn procedure that allows you to calibrate
the sunroof when the “Express Operation”
feature stops working. To reset the sunroof,
follow these steps:
1. Place the ignition in the ACC or the ON/
RUN position.
2. Ensure that the sunroof is in the fully closed
position.
3. Push and hold the close switch. The sunroof
will hit the hard stop and move to the vent
position after 10 seconds.
4. Release the close switch.
5. Push and hold the close switch again within
five seconds to begin the teaching process.
The sunroof will complete one full cycle and
return to the fully closed position.
NOTE:
If the close switch is released anytime during
the teach cycle, the procedure will need to be
repeated starting from the first step.
6. Once the sunroof has stopped in the fully
closed position, release the close switch.
The sunroof is now reset and ready to use.
Dual Pane Power Sunroof — If Equipped
The power sunroof switches are located on the
overhead console between the courtesy/
reading lights.
Power Sunroof Switches
1 — Opening/Closing Sunroof
2 — Venting Sunroof
3 — Opening/Closing Sunshade
20_DT_OM_EN_USC_t.book Page 72