STARTING AND OPERATING 235
Off-Road 2 (OR2) (Raises the vehicle approx-
imately 2 inches (51 mm)) – This position is
intended for off-roading use only where
maximum ground clearance is required. To
enter OR2, push the height selector switch up
twice from the NRH position or once from the
OR1 position while vehicle speed is below
20 mph (32 km/h). While in OR2, if the
vehicle speed exceeds 25 mph (40 km/h)
the vehicle height will be automatically
lowered to OR1. Off-Road 2 may not be avail-
able due to vehicle payload, an instrument
cluster message will be displayed when this
occurs. Refer to “Instrument Cluster Display”
in “Getting To Know Your Instrument Panel”
for further information.
Aero Mode (Lowers the vehicle approximately
0.6 inch [15 mm]) – This position provides
improved aerodynamics by lowering the vehicle.
The vehicle will automatically enter Aero Mode
when the vehicle speed remains between
62 mph (100 km/h) and 66 mph (106 km/h) for
greater than 20 seconds or if the vehicle speed
exceeds 66 mph (106 km/h). The vehicle will
return to NRH from Aero Mode if the vehicle
speed remains between 30 mph (48 km/h) and
35 mph (56 km/h) for greater than 20 seconds
or if the vehicle speed falls below 30 mph
(48 km/h).
NOTE:
Speed thresholds for raising the vehicle only
apply if Automatic Aero Mode is enabled.
To enter Aero Mode manually push the height
selector switch down once from NRH at any
vehicle speed. To return to NRH push the
height selector switch up once while vehicle
speed is less than 56 mph (90 km/h).
NOTE:
Automatic Aero Mode may be disabled through
vehicle settings in the instrument cluster
display or through your Uconnect Radio if
equipped. Refer to “Instrument Cluster Display”
in “Getting To Know Your Instrument Panel” or
“Uconnect Settings” in “Multimedia” for further
information.
Entry/Exit Mode (Lowers the vehicle approxi-
mately 2 inches (51 mm)) – This position
lowers the vehicle for easier passenger entry
and exit as well as lowering the rear of the
vehicle for easier loading and unloading of
cargo. To enter Entry/Exit Mode, push the
height selector switch down once from the
NRH while the vehicle speed is below 33 mph
(53 km/h). Once the vehicle speed goes
below 15 mph (24 km/h) the vehicle height
will begin to lower. If the vehicle speed
remains between 15 mph (24 km/h) and
25 mph (40 km/h) for greater than
60 seconds, or the vehicle speed exceeds
25 mph (40 km/h) the Entry/Exit change will
be cancelled. To return to Normal Height
Mode, push the height selector switch up
once while in Entry/Exit or drive the vehicle
over 15 mph (24 km/h). Entry/Exit mode
may not be available due to vehicle payload,
an instrument cluster message will be
displayed when this occurs. Refer to “Instru-
ment Cluster Display” in “Getting To Know
Your Instrument Panel” for further informa-
tion.
CAUTION!
If the vehicle is in OFFROAD1 or OFFROAD2
setting, be aware of your surroundings, you
may not have the clearance required for cer-
tain areas and vehicle damage may occur.
5
20_DT_OM_EN_USC_t.book Page 235
To Next Page
