To Unlock From The Driver Or Passenger Side:
With a valid Keyless Enter-N-Go Key Fob
located outside the vehicle and within
5 ft (1.5m) of the driver or passenger side
door handle, grab either front door
handle to unlock the door automatically.
KEYLESS ENTER-N-GO — IGNITION
Starting
With a valid Keyless Enter-N-Go Key Fob
inside the vehicle:
1. Shift the transmission into PARK.
2. While pushing the brake pedal, push
the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically
after 10 seconds.
3. To stop the cranking of the engine
prior to the engine starting, push the
button again.
NOTE:
In case the ignition switch does not change with the push of a button, the RKE Key
Fob may have a low or dead battery. In this situation, a back up method can be used
to operate the ignition switch. Put the nose side of the Key Fob (side opposite of the
Emergency Key) against the ENGINE START/STOP button and push to operate the
ignition switch.
Stopping
1. Bring the vehicle to a complete stop.
2. Shift the transmission to PARK (P).
3. Push the ENGINE START/STOP button once. The ignition switch will return to the
OFF position.
Grab The Door Handle To Unlock
Start/Stop Button
GETTING STARTED
14
To Next Page
Loading...
