RAM 3500 - UNIVERSAL GARAGE DOOR OPENER (Homelink)

Audio
• Push the UP or DOWN arrow button until the Audio display icon is
highlighted in the EVIC/DID. This screen will display the current media source.
Screen Setup
• Push the UP or DOWN arrow button until the Screen Setup display icon is
highlighted in the EVIC/DID. Push the RIGHT
arrow button to enter the Screen
Setup sub-menu. The Screen Setup feature allows you to change what information
is displayed in the instrument cluster as well as the location that information is
displayed.
UNIVERSAL GARAGE DOOR OPENER (HomeLink)
HomeLink replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems. The
HomeLink unit is powered by your vehicles 12 Volt battery.
The HomeLink buttons that are located in the overhead console or sunvisor designate
the three different HomeLink channels.
The HomeLink indicator is located above the center button.
Before You Begin Programming
HomeLink
Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new battery
be placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink system.
To erase the channels, place the ignition
switch into the ON/RUN position, then
push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds or
until the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink for the
first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free
1-800-355-3515 or, on the Internet at HomeLink.com for information or assistance.
Universal Garage Door Opener (HomeLink)
Buttons
ELECTRONICS
161