Air Recirculation
• Use Recirculation for maximum A/C operation.
• For window defogging, turn the Recirculation button off.
• If the Recirculation button is pushed while in the AUTO mode, the indicator light
may flash three times to indicate the cabin air is being controlled automatically.
Heated Mirrors
The mirrors are heated to melt frost or ice. This feature is activated whenever you turn
on the defroster.
PARKSENSE FRONT AND REAR PARK ASSIST — IF EQUIPPED
The ParkSense Park Assist system provides visual and audible indications of the
distance between the rear and/or front fascia and a detected obstacle when backing
up or moving forward, e.g. during a parking maneuver. Refer to ParkSense System
Usage Precautions for limitations of this system and recommendations.
ParkSense will retain the last system state (enabled or disabled) from the last ignition
cycle when the ignition is changed to the ON/RUN position.
ParkSense can be active only when the gear selector is in REVERSE or DRIVE. If
ParkSense is enabled at one of these gear selector positions, the system will remain
active until the vehicle speed is increased to approximately 7 mph (11 km/h) or
above. A display warning will appear in the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID) indicating the vehicle is above ParkSense
operating speed. The system will become active again if the vehicle speed is
decreased to speeds less than approximately 6 mph (9 km/h).
Cleaning The ParkSense Sensors
If “PARKSENSE UNAVAILABLE WIPE REAR SENSORS" or "PARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORS” appears in the “Electronic Vehicle Information
Center (EVIC) or Driver Information Display (DID),” clean the ParkSense sensors with
water, car wash soap and a soft cloth. Do not use rough or hard cloths. Do not scratch
or poke the sensors. Otherwise, you could damage the sensors.
PARKVIEW REAR BACK UP CAMERA — IF EQUIP PED
Your vehicle may be equipped with the ParkView Rear Back Up Camera that allows
you to see a image of the rear surroundings of your vehicle whenever the gear selector
is put into REVERSE or whenever it is initiated through "Backup Camera" button in
the "Controls" menu. Whenever the gear selector is put into REVERSE, the image will
be displayed in the rearview mirror display (if equipped) or Uconnect screen (if
equipped) along with a caution note to “check entire surroundings” across the top of
the screen. After five seconds this note will disappear.
The ParkView Camera is located to the left of the tailgate handle.
OPERATING YOUR VEHICLE
68
To Next Page
Loading...
