RAM 3500 - Rebel Air Suspension System

Wheel Alignment Mode
Before performing a wheel alignment, this mode must be enabled. Refer to “Elec-
tronic Vehicle Information Center (EVIC)/Driver Information Display (DID)” in “Un-
derstanding Your Instrument Panel” in the Owner’s Manual on the DVD for further
information.
NOTE:
This mode is intended to be enabled with engine running.
Protection Mode
In order to “protect” the air suspension system, the vehicle will enter Protection
Mode when the payload has been exceeded or load leveling cannot be achieved.
Refer to “Electronic Vehicle Information Center (EVIC)/Driver Information Display
(DID)” in “Understanding Your Instrument Panel” in the Owner’s Manual on the DVD
for further information.
NOTE:
This mode is intended to be enabled with engine running.
REBEL AIR SUSPENSION SYSTEM
The air suspension system provides full time load leveling capability along with the
benefit of being able to adjust vehicle height by the push of a button.
Automatic height changes will occur based on vehicle speed and the current vehicle
height. The indicator lamps and EVIC/DID messages will operate the same for
automatic changes and user requested changes.
Rebel Air Suspension Controls
1 — Normal Ride Height Indicator
Lamp
2 — Off-Road Indicator Lamp
3 — Up Button
4 — Down Button
5 — Entry/Exit Mode Indicator Lamp
6 — Aero Mode Indicator Lamp
OPERATING YOUR VEHICLE
55