Dump Feature (Manual Recline Seat Only) — Standard Cab
Actuating the recliner handle will allow the seatback to swing (dump) forward on
manual recliner seats. This “dump” feature allows access to the storage bin behind
the seat.
WARNING!
• Do not stand or lean in front of the seat while actuating the handle. The seatback
may swing forward and hit you causing injury.
• To avoid injury, place your hand on the seatback and actuate the handle, then
position the seatback in the desired position.
HEATED/VENTILATED SEATS
Front Heated Seats
The front heated seats control buttons are located on the center instrument panel
below the climate controls.
If your vehicle is equipped with a touchscreen, the front heated seats control buttons
are also located within the climate or controls screen of the touchscreen.
• Press the heated seat button
once to turn the HI setting On.
• Press the heated seat button
a second time to turn the LO setting On.
• Press the heated seat button
a third time to turn the heating elements OFF.
When the HI-level setting is selected, the heater will provide a boosted heat level
during the first four minutes of operation. Then, the heat output will drop to the
normal HI-level. If the HI-level setting is selected, the system will automatically
switch to LO-level after approximately 60 minutes of continuous operation. At that
time, the display will change from HI to LO, indicating the change. The LO-level
setting will turn OFF automatically after approximately 45 minutes.
NOTE:
The engine must be running for the heated seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with Remote Start, the drivers seat can be programmed
to come on during a remote start.
If your vehicle is equipped with a touchscreen, this feature can be programmed
through the Uconnect system. Refer to “Uconnect Settings” in “Understanding Your
Instrument Panel” in the Owner’s Manual on the DVD for further information.
GETTING STARTED
38
To Next Page
Loading...
