NOTE:
If the vehicle speed remains below 8 mph (13 km/h), the cargo camera image will be
displayed continuously until the touchscreen button "X" to disable display of the
Cargo Camera image is pressed.
The Cargo Camera is located in the bottom center area of the center high-mounted
stoplamp (CHMSL).
A touchscreen button
to indicate the current active Camera image being
displayed is made available whenever the Cargo camera image is displayed.
Also, a touchscreen button
to switch the display to Rear View camera image
is made available whenever the Cargo camera image is displayed.
A touchscreen button "X" to disable display of the camera image is made available
when the vehicle is not in REVERSE gear.
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the
lens, rinse with water, and dry with a soft cloth. Do not cover the lens.
Turning Cargo Camera On Or Off — With Uconnect 8.4A/8.4AN
1. Press the “Controls” button located on the bottom of the Uconnect display.
2. Press the “Cargo Camera” button
to turn the Cargo Camera system ON.
NOTE:
Once initiated by the "Cargo Camera" button, the Cargo Camera image may be
deactivated by pressing the "X" soft button. On deactivation, the previous selected
screen will appear.
Cargo Camera Display
UTILITY
177
To Next Page
Loading...
