LATCH System Weight Limit
You may use the LATCH anchorage system until the combined weight of the child and
the child restraint is 65 lbs (29.5 kg). Use the seat belt and tether anchor instead of
the LATCH system once the combined weight is more than 65 lbs (29.5 kg).
Locating LATCH Anchorages
The lower anchorages are round bars that are found at the rear of the seat cushion
where it meets the seatback. They are just visible when you lean into the rear seat to
install the child restraint. You will easily feel them if you run your finger along the gap
between the seatback and seat cushion.
Locating Tether Anchorages
In addition, Regular Cab models have tether strap anchorages behind the front
center and right seats. Quad Cab, Mega Cab and Crew Cab models have tether strap
anchorages located behind each of the rear seats.
Center Seat LATCH (Regular/Quad/Crew Cab Full Bench)
Do not install a child restraint in the center position using the LATCH system. Use the
seat belt and tether anchor to install a child seat in the center seating position.
Center Seat LATCH (Mega/Crew Cab Split Bench)
If a child restraint installed in the center position blocks the seat belt webbing or
buckle for the outboard position, do not use that outboard position. If a child seat in
the center position blocks the outboard LATCH anchors or seat belt, do not install a
child seat in that outboard position.
Lower Anchors
GETTING STARTED
23
To Next Page
Loading...
