Tether Strap Installation
Regular Cab Trucks:
In the regular cab truck, the top tether anchorages are located behind the center and
right passenger seats. There is a plastic cover over each anchorage. To attach the
tether strap of the child restraint:
Mega Cab Trucks:
In the regular cab truck, the top tether
anchorages are located behind the center
and right passenger seats. In the mega
cab truck, the top tether anchorages are
located behind each rear seating posi-
tion. There is a plastic cover over each
anchorage. To attach the tether strap of
the child restraint:
1. Place the child restraint on the seat
and adjust the tether strap so that it
will reach over the seat back, under
the head restraint and to the tether
anchor directly behind the seat.
2. Route the tether strap to provide the
most direct path between the anchorage and the child seat. The tether strap
should go between the head restraint posts underneath the head restraint. You
may need to adjust the head restraint to the upward position to pass the tether
strap underneath the head restraint and between its posts.
3. Lift the cover (if equipped) and attach the hook to the square opening in the sheet
metal. Tighten the tether strap according to the child seat manufacturer’s
instructions.
Quad/Crew Cab Trucks:
The top tether anchorages in this vehicle are tether strap loops located between the
rear glass and the back of the rear seat. There is a tether strap loop located behind
each seating position. Follow the steps below to attach the tether strap of the child
restraint.
Regular Cab Tether Anchorages
GETTING STARTED
26
To Next Page
Loading...
