RAM 3500 - Page 64

Refer to “Electronic Vehicle Information Center (EVIC) or Driver Information Display
(DID)” in “Understanding Your Instrument Panel” in your Owner’s Manual on the
DVD for further information.
To Manually Turn Off The Stop Start System
1. Push the STOP/START Off switch (located on the switch bank). The light on the
switch will illuminate.
2. The STOP/START OFF message will
appear in Electronic Vehicle Informa-
tion Center (EVIC)/Driver Information
Display (DID). Refer to “Electronic
Vehicle Information Center (EVIC)” or
“Driver Information Display (DID)” in
“Electronics” for further information.
3. At the next vehicle stop (after turning
off the STOP/START system) the en-
gine will not be stopped.
4. If the STOP/START system is manu-
ally turned off, the engine can only be started and stopped by cycling the ignition
switch.
5. The STOP/START system will reset itself back to an ON condition every time the
key is turned off and back on.
To Manually Turn On The Stop Start System
1. Push the STOP/START Off switch (located on the switch bank).
2. The light on the switch will turn off.
System Malfunction
If there is a malfunction in the STOP/START system, the system will not shut down
the engine. A “SERVICE STOP/START SYSTEM” message will appear in the Elec-
tronic Vehicle Information Center (EVIC)/Driver Information Display (DID). Refer to
“Electronic Vehicle Information Center (EVIC)” or “Driver Information Display (DID)”
in “Electronics” for further information.
The system will need to be checked by your authorized dealer.
STOP/START OFF Switch
OPERATING YOUR VEHICLE
62