Voice Command Tips
• Speaking complete names (i.e; Call John Doe vs. Call John) will result in greater
system accuracy.
• You can “link” commands together for faster results. Say “Call John Doe, mobile,”
for example.
• If you are listening to available voice command options, you do not have to listen
to the entire list. When you hear the command that you need, push the
button on the steering wheel, wait for the beep and say your command.
Changing The Volume
• Start a dialogue by pushing the Phone button , then say a command for
example - "Help".
• Use the radio VOLUME/MUTE rotary knob to adjust the volume to a comfortable
level while the Uconnect
®
system is speaking. Please note the volume setting for
Uconnect
®
is different than the audio system.
NOTE:
To access help, push the Uconnect
®
Phone button on the steering wheel and say
"help." Press the display or push either the Phone
or VR button and say
"cancel" to cancel the help session.
Incoming Text Messages
After pairing your Uconnect
®
system with a Bluetooth
®
enabled mobile device with
the Message Access Profile (MAP), the Uconnect
®
system can announce a new
incoming text message and read it to you over the vehicle’s audio system.
NOTE:
Only incoming text messages received during the current ignition cycle can be
viewed/read.
ELECTRONICS
46
To Next Page
Loading...
