R&S ZNA26 - Page 643

GUI reference
R&S
®
ZNA
643User Manual 1178.6462.02 ─ 20
Remote command:
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:SEGMent<Seg>:COUNt
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:SEGMent<Seg>:STATe
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:SEGMent<Seg>:STARt
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:SEGMent<Seg>:STOP
Pulse modulator control
Allows you to control the internal pulse modulators (with options R&S ZNAxx-B4y) and
external pulse modulators via PuMo In/Out and Trigger Out (with option R&S ZNA-
B91).
Pulse Modulator Control
If the R&S ZNA is equipped with the Trigger board, the Internal pulse modulators can
be controlled externally, via the PuMo In connectors.
Remote command:
[SENSe<Ch>:]PULSe:INTernal[:STATe]
Port
Activates or deactivates the respective internal pulse modulator.
The internal pulse modulator for port y is provided by option R&S ZNAxx-B4y. If this
option is not installed, the corresponding checkbox is disabled.
Remote command:
[SENSe<Ch>:]PULSe:PORT<Pt>[:STATe]
PuMo Out
These settings control the generation of an outgoing pulse generator signal at the cor-
responding PuMo In/Out, with either positive or negative polarity.
Remote command:
[SENSe<Ch>:]PULSe:PORT<Pt>:EXTernal:OUTPut[:STATe]
[SENSe<Ch>:]PULSe:PORT<Pt>:EXTernal:OUTPut:INVerted[:STATe]
Mode softtool